This software is found in the Start Menu under FactoryTalk Tools. You can also find the pop-ups window messages described above in Rockwell's Diagnostic viewer. The grace period has ended for (product name.)” The software should now run with the features enabled by the activation used. If you activate the software after the “Grace Period” has expired you'll be greeted with a third pop-up which reads, “This product has been activated.
For those products with a demo or free mode (RSView, RSLinx) the software will start in that mode. It reads, “Failed to activate (product name.) The grace period has expired.” For those products without a demo mode (like RSLogix) you'll be asked to activate the product and if you chose not to the product will not launch. Once the “Grace Period” ends, a second popup will be displayed upon subsequent launching of the software. The “Grace Period” is also not resettable by changing the PC's clock back in time, as once the seventh day triggers the end of the “Grace Period” the software will no longer run in “Grace Period” mode no matter how the PC clock is manipulated. When the software is launched for the first time without activation, the client will be greeted with a pop-up window stating, “The product has not been activated but will continue to run in a grace period for seven days.” This seven day period is from the moment this pop-up first appears, and even if the software is not launched again during this period it will still expire exactly seven days later. Note that during installation some multi-version products, like RSLogix 5000, do require a valid serial number to run in “Grace Period” mode in the desired version (i.e. To utilize the “Grace Period,” clients install their Rockwell Software on a new PC (or virtual machine) that has not previously had the software in question running in “Grace Period” mode. In an emergency situation, if the client's PC crashed and they were in a remote location without the ability to contact Rockwell's activation group for a reset, this “Grace Period” mode gave them a temporary solution to get back up and running quickly. This “Grace Period” allowed customers to install and run the software on a new PC for up to seven days without activation.
To address this, in CPR9 Rockwell added a FactoryTalk Activation “Grace Period” mode into software products which used FactoryTalk activation. For some it was the fact that the older “Floppy Master Disk” activation would allow the use of the original “Master Disk” as a back-up activation in case the movable activation file was lost or corrupted. When FactoryTalk Activation (FTA) was first released, many clients expressed reservations about moving to it.
0 kommentar(er)
